Lumenera's download centre provides customers with the most current versions of our software releases. You can refer to your User's Manual for instructions on software upgrade procedures, or, access our Knowledge Base for instructions. The Knowledge Base provides customers with a variety of solutions and reference materials. Our Knowledge Base is provided to all Lumenera customers, therefore, if you don't already have a user name and password, please contact support@lumenera.com. Our FAQ section is open to anyone needing general information on our products.
© 2008 Lumenera Corporation. All rights reserved.
Sitemap | Legal | Privacy | Quality | RMA
Important note for USB based cameras: When downloading a Software Upgrade, note that the software will prompt you to uninstall the previous version of software. You can also uninstall the previous version of the software manually before you download the latest version, but you need to reboot your computer (if prompted) to ensure that you do not experience difficulties with future software upgrades.
* The above link will download the necessary software to run the camera on an Apple MacIntosh computer. It includes a plug-in to work with the ImageJ software package which can be found at http://rsb.info.nih.gov/ij/. You should install ImageJ before installing the INFINITY Mac Software to ensure that the plug-in installs correctly. Note: The Mac Interface does not support the INFINITY2-3 camera model.
Contact your camera dealer or a Lumenera sales
representative at sales@lumenera.com for information on the availability of Linux Drivers for Lumenera USB camera models.
This Lumenera USB 2.0 Camera LabVIEW plug-in allows the creation of LabVIEW VIs that can be used to control all Lumenera USB 2.0 cameras. It supports LabView and Vision Builder AI versions 7.1, 8.0, 8.2 and 8.5 only.
This plug-in requires the installation of LabVIEW, the NI Vision Development Module, and the applicable Lumenera Software for your camera model.
If you have any questions about LabVIEW, contact National Instruments directly at www.ni.com. If you have any camera specific questions contact our TAC team at support@lumenera.com.
To install this driver, extract all the files within the compressed zipped file into a directory of your choice. From within MatLab, select File-> Set Path->Add Folder... In the Add Folder dialog, add the path to the installation location of the Lumenera MatLab driver.
This version of the Lumenera MatLab driver will only work with MatLab R2006. It will not work with previous versions of MatLab.
Please ensure that your camera is using firmware 1.7.0.4 or higher (e.g. 1.8.0.10) before upgrading to version 1.8.0.16. For older firmware, please email support@lumenera.com to obtain all necessary firmware files.
Note: Internet Explorer is required to download the following firmware.
STEP 1: Upgrade boot version
STEP 2: Upgrade main firmware
STEP 3: Enable the Watchdog and Save Settings.
STEP 1: Upgrade boot version
STEP 2: Upgrade main firmware.
STEP 3: Upgrade video analytics firmware.
